Specifications: Name: Hand press nest base machine Additional gift: 12V power supply, 12V miniature brushless water pump, water pipe, copper tee, clamp, etc. Operation steps: 1. Directly wax the wax, with a temperature not exceeding 200 degrees Celsius. Generally, it can be hardened without boiling or smoking Directly pour wax, if there are temperature control conditions, it is recommended to adjust it to 120 degrees. (When wax water boils, it can reach 300 degrees) 2. Place the nest base machine flat and do not need to brush the mold release water. 3.Simply pour the wax water evenly into the bottom mold. Pour it out in about 8 seconds. Press for 10 seconds and then release. 4. Wait for about 1 minute before opening the mold. 5. First, clean the remaining wax at the edges and corners. After the wax temperature drops, it can be peeled off. 6. Then move on to the next one. General requirements: The wax temperature should not exceed 200 degrees, the mold should be cold, the wax water should be hot, the wax pouring time should be short, and the wax pouring water should be even.

مواصفات المنتج