Product information

HAMGEEK Original PLUTO+ ADC/DAC AD9363 SDR Radio Receiver Transmitter 70MHz-6GHz Software Defined Radio ADI ADALM-PLUTO Plus Product Overview: HamGeek PLUTO+ is a software-defined radio platform that supports 2TX and 2RX, supports Gigabit Ethernet and Micro SD card. It refers to the design for well-known ADI ADALM-PLUTO and improves its shortcomings. Features: - ADC/DAC: AD9363 (Can hack to AD9361 or AD9364) - 2 Transmit, 2 Receiving channel - RF Range: 70MHZ~6GHZ - Ref Clock: VCTCXO 40MHZ 0.5ppm - SOC: for Zynq7010 FPGA: 28k - RAM: 512M - FLASH: 32M - USB: 2.0, support OTG - Ethernet: 1000Mb - Micro SD can use to boot - DC IN: 5V±0.5V-2A microUSB Interfaces: Please note that all IO levels are 1.8V. 3.1 When using the official firmware for ADI-PlutoSDR, please connect to URST-MI052. 3.2 When using Pluto+ firmware and need to support Ethernet, please connect URST-MIO46 3.3 When using SD card to boot, please connect SD-H to 1V8 3.4 When using JTAG to debug, please connect JTAG# to GND 3.5 Please connect EXCLK to GND when using external reference clock input PTT Key Port: - PTT drives optocouplers through GPIO0 (MI00), which requires an external relay or control circuit. DFU KEY: - At any time, you can press the DFU button and power on PLUTO+ again to enter the DFU mode, but you need to connect the URST jumper to MI052. Ref CLK input IPEX: - You can connect a cable to input an external high-precision reference clock for AD9363 through the IPEX interface. - The main level should not exceed 3.3V, and the EXCLK jumper needs to be connected to GND to turn off the built-in clock Calibrate the Frequency of Built-in VCTCXO: - The frequency of the 40M clock can be fine-tuned by adjusting the adjustable resistor next to the VCTCXO, provided that you have a reference signal source. Micro-SD: Support booting via SD card, need to connect SD-H jumper to 1V8. PLUTO+ Standard Package Included: - 1 x SDR Radio PLUTO+ PLUTO+ Standard with Antenna Package Included: - 1 x SDR Radio PLUTO+ - 1 x USB cable - 1 x 8dBi 2.4GHz/5GHz/5.8GHz antenna - 1 x 5dBi 40MHz-860MHz antenna - 1 x 40MHz-6GHz telescopic antenna - 1 x 12dBi 700MHz-2700MHz antenna Note: - It is assembled and ready to use. - SD card is not included in the package.