Product information: Product capacity: 200VA Average power: 250W Input voltage: AC 110 240V Working current: 0.1A-2A Size: 100*1 15* 205 mm Weight: 1kg Key Technical points: Coaxial cable signal transmission Drive arc extinguishing isolation device i Set i meter without ground wire 220v direct power supply 20m Arc discharge distance 3.5mm audio port Product Features: 1. Easy to use and easy to operate 2. Safe and risk-free 3. It can be directly powered on without installing a ground cable 4. No need to connect multiple power supplies, directly connect to the socket 220v, you can use 5. The arc length can be adjusted at will, up to more than 20cm 6. Small size, strong structure, easy to carry Usage of the new model: 1. Place the thimble on the pressure equalization ring at the top, with the tip extending out of the ring About 2-3cm is best. 2. Turn the knob counterclockwise to turn off the arc and adjust the light brightness to Minimum, and then close the arc. 3. Connect the two ends of the optical fiber to the product body and the controller. Pay attention to the optical fiber There is a bump on the head, do not be hard against, first rotate and then plug. 4. Connect the 220v power cable to the host and then to the 220v power cable Socket link. 5. Finally, open the controller switch, and turn the potentiometer can be out It's arcing. Points to note: ★ Do not directly touch the coil or voltage equalization ring at any time after the product is energized. ★ The safety distance of the product is at least 0.5m, and 1m is recommended. On the distance to watch ★ Open or close, must ensure that the potentiometer in the 0 position. ★ The new SSTC must be installed with a thimble and then powered on. It is recommended to use the SSTC within 3-5 minutes each time, and play music within 2-3 minutes Packing list: Tesla coil x 1pc Optical fiber x 1pc Power cable x 1pc Audio cable x 1pc usb cable x 1pc Controller x 1pc

Product specifications